Home  /  Printing data

Printing data

REQUIREMENTS FOR THE PREPARATION OF PRINT DATA

 

To produce a high quality final product, it is necessary to provide the print data according to the following rules:

 

  • Deliver the print data in Adobe PDF version 1.3.
  • Use CMYK color model or Pantone system for your documents, without embedded ICC profiles (color management).
  • In case of using ICC profiles, transparencies or RGB, we accept only documents of PDF/X standards intended for this purpose.
  • Use bitmap images in a resolution of 300 dpi (minimum 200 dpi), 1-bit images in a resolution of 1200 dpi (minimum 600 dpi).
  • Fonts must be attached in the document.
  • Bleed (graphics overlap beyond the edge of the sheet) must be 3 mm on each side.

 

In the event that you are unsure about the correct procedure when preparing print data, do not hesitate to contact our prepress staff: (+420) 543 216 947.

 

 

Data transport

  • Data up to 10 MB can be sent to data@tiskarna-didot.cz
  • FTP – access information will be sent on request.
  • Use on-line service uschovna.cz for large amounts of data (up to 7 GB).

 

 

Diagram of correct bleed setting

 

 

Tiskárna Didot, spol. s r.o.

Trnkova 119, 628 00 Brno-Líšeň

tel.: +420 543 215 538, e-mail: info@tiskarna-didot.cz

Copyright © 2015 Tiskárna Didot, spol. s r.o.